Please note: due to the amount of Spam email we receive as a result of having our email addresses on this website, we have substituted the @ symbol for the letters -AT- simply remove the -AT- and replace with the @ symbol to email us.

Guardian Hoist Controller
Wall Mounted

LTM build a range of controllers in wall mounted enclosures. They have a wide range of uses for permanent installations.

We start with a wall mounted enclosure, we build the electrical components onto the rear chassis enclosure plate.

Outlets to hoists are normally hard wired onto DIN rail terminals situated at the base of the unit.

Input power is normally hard wired, however we can provide a short extension cable with CEE connector if required.

The opening door of the controller has a green power LED, lockable E-Stop and a door isolator.

The door has a connector for the handset cable to plug into.

Controllers for both Direct Control and Low Voltage Controlled hoists are available for 400V, 3 Ph, 50Hz power supply as are single phase units for 220V, 1Ph, 50Hz

Control

Supplied with a remote hand set with run button and lockable E-Stop, toggle switches are provided for each hoist with up, neutral and down.

15 metres of cable is supplied between the handset and the plug in point on the controller.

Options are available for either Direct Control or Low Voltage controlled hoists, single phase controllers are also available.

Options

Aluminium stage boxes are available so that a plug in point for the controller can be provided at stage level where perhaps the controller is mounted at higher level

Controllers for Single Phase power supply 220V, 1Ph, 50Hz are available

LED directional indicators on the handset